Kiln Elements · Single elements from $90 · Full sets from $250
Kiln elements, wound to your kiln's exact spec
We wind kiln elements ourselves on in-house machines, to the resistance your kiln was designed around. Element wire is specified by model and serial, because manufacturers revise coil specifications across production runs — a set that fits a 2014 kiln may not suit the same model built in 2021.
Diagnose first
What the symptoms are telling you
Work out what has actually failed before you order. We would rather talk you out of a part you do not need than sell you the wrong one.
Firings take progressively longer
The classic ageing signature. Element wire oxidises, its cross-section thins and resistance climbs, so the kiln draws less current and makes less heat each firing.
Do this: Track your firing times — a creeping increase is the earliest warning you will get.
Kiln stalls before reaching temperature
Elements have degraded past the point where they can hold the top of the ramp, or the controller has errored out on a rate fault.
Do this: Note the temperature at which it stalls. Consistent stalls point squarely at elements.
Uneven firing top to bottom
One ring's elements have aged faster than the others, which is common because the top and bottom rings work hardest.
Do this: Measure resistance ring by ring and compare — the odd reading identifies the ring.
Visible break or bright spot in the coil
The element has burned through, or a section has thinned and is now running hotter than the rest of the run.
Do this: Replace the full set rather than the single broken element.
Brands we wind for
Matched to your equipment, whoever made it
We wind to factory resistance for these makes. Do not see yours? We wind for almost anything — send the details.
Work it out yourself first
Free tools and guides. We would rather you ordered the right part than ordered twice.
Kiln questions
How many firings should I get from a set of elements?
It depends heavily on the kiln and how hot you fire. A smaller kiln that is generously powered for its volume can deliver a great many more firings than a large-volume kiln worked regularly at cone 6. Firing temperature is the dominant factor — sustained high-cone work shortens element life sharply. Tracking firing times gives you far better warning than counting firings.
One element broke. Do I have to replace them all?
We recommend replacing the full set, and so do the kiln manufacturers. The remaining elements have the same hours and the same oxidation, so a second failure within a few firings is common. More importantly, a new low-resistance element sitting beside aged high-resistance ones puts out noticeably more heat and fires unevenly.
Why do you need my kiln's serial number?
Manufacturers revise element specifications during a model's production life. Two kilns badged identically but built years apart can take genuinely different elements. The serial is how we make sure the set we wind matches the kiln you actually own.
What does winding to ±2% tolerance actually mean for me?
Resistance determines how much heat an element produces. If a set is wound loosely to tolerance, the elements do not match each other and the kiln fires unevenly — hot at one ring, cool at another. Holding ±2% across a set is what keeps the chamber even, which is why we measure every coil against target before it ships.
Can I make my elements last longer?
Fire no hotter than the work needs, vent properly so the wire is not sitting in a reducing atmosphere, keep the element grooves clean of glaze drips, and avoid holding at peak longer than required. Glaze contamination on the coil is a fast route to a dead element.
Get a quote
Tell us about your kiln
Model number, a photo of the data plate, or the old element on a tape measure — any of those and we can spec your replacement.