Kiln · Cone Art
Cone Art replacement elements
Cone Art is a Canadian-built kiln and the BX range is well known in Ontario studios, with double-wall construction that holds heat more evenly than a single-wall shell but also means the elements run in a slightly different thermal environment than a comparable single-wall kiln.
Find your Cone Art model
We hold element counts and supply voltages for 4 Cone Art models. Pick yours and we will confirm the spec back to you before asking for anything.
Cone Art element specifications
Typical ranges across the Cone Art lines we see most. Always confirm against your own rating plate.
Where to find the data tag on a Cone Art
The data plate on Cone Art kilns is typically mounted on the control box exterior, close to the switches or digital controller. Because Cone Art uses double-wall construction, the element grooves sit behind an extra layer of insulation, so read the model and serial from the plate rather than trying to guess dimensions by eye through the firing chamber.
Model series we supply
- BX-2327
- BX-1822
- BX-2336
- BX-2722
What is specific about Cone Art
Cone Art is a Canadian-built kiln and the BX range is well known in Ontario studios, with double-wall construction that holds heat more evenly than a single-wall shell but also means the elements run in a slightly different thermal environment than a comparable single-wall kiln. Element count runs from four sections in the smaller BX-1822 up to eight in the BX-2336. We wind these to order from Kanthal A1 rather than pulling from generic stock, matching the original resistance within ±2%, and our standard lead time is 48 hours. As with any brand, confirm the supply voltage from the data plate since a 240V and 208V winding are not the same part even for an identical physical coil length.
How Cone Art elements typically fail
- Element sagging or lifting from the groove, sometimes less visible than on single-wall kilns due to the double-wall shell
- Section failure from thinning wire, often after years of cone 6 or higher firings
- Terminal block corrosion or a loose pigtail connection producing an intermittent or dead section
- Uneven firing across the chamber, which on a double-wall kiln is a strong hint that one element bank has failed rather than a venting issue
Confirm before you order
Test the element before replacing it. A meaningful share of "dead element" calls turn out to be a thermostat, sequencer or limit switch, and the test takes ten minutes with a multimeter. Our resistance test tool tells you what your reading means.
What to send us for a Cone Art quote
- Model and serial from the rating plate
- Voltage and wattage, if legible
- A photo of the old element, especially the terminal end
- What the equipment is doing — or failing to do
If the plate has faded past reading, our model number guide covers the other places manufacturers record it.
Other kiln brands
Cone Art element questions
Does the double-wall construction change how the elements are wound?
The wire itself is wound the same way, from Kanthal A1 to the correct resistance and coil pitch, but we do take the double-wall geometry into account when confirming groove depth and element length, since it can differ slightly from a single-wall kiln of similar chamber size. Sending us the model and serial, or the old element for reference, lets us match this exactly.
My Cone Art kiln is underfiring on one side. Is that an element problem?
It often is. On a double-wall kiln, uneven heating is less likely to be a venting or insulation issue and more often points to one element section that has thinned or opened. Testing each section's resistance with a multimeter against the data plate spec, or against the other sections, will usually confirm it.
What information do you need to wind a replacement for my BX model?
The model number and serial off the control box plate is the starting point, since Cone Art has adjusted element specifications across production runs. If you have the old element, its wire gauge and groove length let us confirm the winding even without a fully legible plate.
Get a quote
Get a Cone Art element quote
Send the model and serial, or a photo of the rating plate. We confirm the exact fit in writing before anything ships.