Furnace · Coleman
Coleman replacement elements
Coleman's HVAC division, owned by Johnson Controls, is a separate business from the Coleman camping and outdoor brand, and confusing the two is a common mistake when homeowners search for parts online.
Coleman element specifications
Typical ranges across the Coleman lines we see most. Always confirm against your own rating plate.
Where to find the data tag on a Coleman
Coleman air handlers are part of the Johnson Controls residential range, with the main rating plate mounted just inside the front door of the cabinet and the heat kit's own label on a slide-out tray beneath the blower compartment. Confirm you are reading the tray label, since the cabinet plate does not list heater amperage.
Model series we supply
- Echelon
- TC6
- HC6
What is specific about Coleman
Coleman's HVAC division, owned by Johnson Controls, is a separate business from the Coleman camping and outdoor brand, and confusing the two is a common mistake when homeowners search for parts online. Coleman shares platform engineering with York and Luxaire under the same Johnson Controls umbrella, so heat kit dimensions and staging logic often line up closely with those siblings. As with most of this corporate group, Coleman air handlers are sold through HVAC contractors rather than retail, leaving homeowners without a straightforward parts counter to walk into. The heat kit tray uses the same sequencer-staged inrush control common across the industry, with each stage brought on a few seconds behind the last.
Also sold as Coleman HVAC, Coleman Heating and Air Conditioning
These brands share manufacturing platforms with Coleman, and elements frequently cross over between them when wattage, voltage and mount match. We verify against your specific model rather than assuming — sharing varies by generation and product line.
How Coleman elements typically fail
- Element burned open from long-term filter neglect restricting airflow across the coil
- Sequencer failing to close, which reads as no heat at all rather than a partial loss of stages
- Loose terminal connections on the tray causing localised overheating and eventual open circuit
Confirm before you order
Test the element before replacing it. A meaningful share of "dead element" calls turn out to be a thermostat, sequencer or limit switch, and the test takes ten minutes with a multimeter. Our resistance test tool tells you what your reading means.
What to send us for a Coleman quote
- Model and serial from the rating plate
- Voltage and wattage, if legible
- A photo of the old element, especially the terminal end
- What the equipment is doing — or failing to do
If the plate has faded past reading, our model number guide covers the other places manufacturers record it.
Coleman element questions
Is Coleman HVAC the same company as the Coleman camping brand?
No, they are entirely separate businesses. Coleman's residential furnace and air handler line is owned by Johnson Controls and shares engineering with York and Luxaire, while the camping and outdoor gear brand has no connection to the HVAC equipment.
None of my Coleman heat kit stages will turn on. What's the likely cause?
When every stage stays cold at once, the fault is almost always upstream of the elements themselves, in the sequencer or the control board, rather than in the elements. If even one stage were to energise while others stayed dead, that would point instead to burned-open elements on just those stages.
How do I size a replacement element for a Coleman heat kit without the part number?
Read the kW, voltage and amperage straight off the tray label and take a physical measurement of the element's length and terminal spacing. A manufacturer that winds to specification can match those figures directly without needing the original Johnson Controls part number.
Get a quote
Get a Coleman element quote
Send the model and serial, or a photo of the rating plate. We confirm the exact fit in writing before anything ships.